I. Salinomycin Sodium Dryer--Overview of Equipment

Sodium salinomycin is a white or light yellow crystalline powder; slightly specific odor. This product is soluble in methanol, ethanol, acetone, ether and chloroform. It is slightly soluble in n-hexane and insoluble in water.

Jaw dryer is suitable for veterinary drug raw materials: salinomycin sodium, tylosin, colistin sulfate, apramycin, spectinomycin, ceftiofur, tilmicosin, tiamulin, fluni Production of raw materials such as octylamine.

The salinomycin sodium vacuum crucible dryer is a conductive heat transfer dryer. The material is not directly in contact with the heating medium, and is suitable for drying a small amount of mud-like or paste-like material which is not resistant to high temperature and is easily oxidized, and has a water content of 15% to 90%. The internal teeth of the dryer are made of steel and mounted on a circular hot shaft with half of the blades to the left and the other half to the right. The shaft speed is generally less than 15r/min, which is driven by a motor with a reduction gearbox. At the same time, the automatic steering device is adopted to change the rotation direction of the agitator after the rotation direction of the shaft is separated by a certain time.

The vacuum kneading dryer is a device that uses the moisture in the material or the solvent to reduce the boiling point under vacuum. The material to be dried is added from the upper part of the upper part of the casing. Under the stirring of the teeth which are continuously reversed and reversed, the material moves back and forth in the axial direction, and steam or other heating medium and materials are passed through the outer wall surface of the casing, the hot shaft and the molars. The indirect heat exchange causes the water in the material to vaporize, and the vaporized water is pumped out of the dryer in time.

The salinomycin sodium vacuum squeezing dryer has an inner cavity on the molar, and when the molar is fixed on the hot shaft, the inner cavity on the molar communicates with the hot shaft, and the heat medium (steam or hot water) can be taken from the hot shaft. Inflow into the molar cavity, so that the heat exchange area is greatly increased compared with the prior art solid or round tube; the adjustable connection between the scraper and the molar is different from other welded structures. It is convenient to adjust the gap between the scraper and the inner wall surface of the cylinder, which can effectively compensate for the actual manufacturing and processing problems such as roundness deviation of the cylinder, welding distortion of the stirring shaft and the molar, and at the same time, it is convenient for the scraper to be replaced for the material with high abrasiveness.