I. Titanium double cone cyclone vacuum dryer--Overview


Titanium double cone convoluted vacuum dryer is a new type of drying machine that combines and drys. The condenser, the vacuum pump and the dryer are matched; a vacuum drying device is formed. (If there is no need to recover the solvent; the suspect can be used) The machine is designed; the internal structure is simple; the cleaning is easy to discharge all the materials; the operation is simple; the labor intensity can be reduced to improve the working environment. At the same time, the material also rotates when the container itself rotates, but the material does not accumulate on the wall; therefore, the heat transfer coefficient is high; the drying rate is large, not only saves energy; but the material is evenly dried and good; the quality is good. Can be widely used in the drying of materials in the pharmaceutical, chemical, food, fuel and other industries. Meet GMP requirements.


Second, titanium double cone cyclone vacuum dryer - characteristics


Titanium double cone cyclone vacuum dryer When heating; automatic constant temperature control; can dry biochemical products and minerals; temperature can be between 20~160 °C; temperature ± 2 °C. High thermal efficiency; more than 2 times higher than the average oven. Indirect heating; materials are not contaminated; meet GMP requirements. Equipment maintenance is simple and easy to clean.


Third, titanium double cone cyclone vacuum dryer - application


Titanium double cone convoluted vacuum dryer is suitable for vacuum drying and mixing of powder and granular materials in medicine, food, chemical industry, etc. It is especially suitable for heat sensitive materials which can not withstand high temperature in the following materials; easy to oxidize; dangerous materials; Recover solvents and toxic materials; require materials with very low residual volatiles; require adequate, uniform materials.


Fourth, titanium double cone cyclone vacuum dryer - principle


 The SZG type is a double-conical rotary tank; the tank is under vacuum; the steam or hot water is heated in the jacket; the heat is in contact with the wet material through the inner wall of the tank. The moisture that evaporates after the wet material absorbs heat; is evacuated through a vacuum exhaust pipe through a vacuum pump. Because the tank body is in a vacuum state; and the rotation of the tank body causes the material to continuously turn up and down, inside and outside; therefore, the drying speed of the material is accelerated; the drying efficiency is improved; and the uniform drying is achieved.